|
| |
| |
DIN-100
Analog Input Modbus Modules
|
|
|
|
| The DIN-100
Modbus data acquisition modules (DAS) are designed for systems based on the Modbus RTU protocol. The modules convert analog input signals to digital data and
transmit via RS485 to a controller which may be a computer or other
processor-based equipment. The DAS modules provide data acquisition from a wide variety of sensors and perform all signal
conditioning, scaling, linearization and conversion to either linearized ASCII
data values or Modbus percent of full scale binary values.
The DIN-100 data
acquisition modules can measure temperature, load cells, bridges, voltage,
current, frequency, as well as digital inputs and digital outputs.
The DIN-100
series is designed to be mounted on the industry standard DIN rail.
|
|
| |
| Measurement
Types: |
| |
| DIN-110 |
Voltage |
+/-10mv,
+/-100mV, +/-1V, +/-5V, +/-10V, +/-100V |
| DIN-120 |
Current |
4-20mA |
| DIN-130 |
Thermocouple |
J,
K, T, E, R, S, B, C |
| DIN-140 |
RTD |
.00385,
.00388, .00392 |
| DIN-145 |
Thermistor |
2252
Ohm, Honeywell TD Series |
| DIN-150 |
Bridge |
+/-30mV,
+/-100mV |
| DIN-160 |
Frequency |
1 Hz to 20KHz |
| DIN-170 |
Digital
I/O |
Digital
I/O Modules |
| DIN-190 |
Converters |
RS-232
to RS-485 Serial Converters |
|
|
|
| Modbus
Software
Compatibility |
| |
| The
DGH Modbus I/O modules are compatible with all
commercial software programs and OPC servers that support the Modbus RTU
protocol. Commercials software programs from Wonderware, Intellution,
National Instruments LabVIEW, and Dasylab all support the Modbus RTU protocol.
OPC Servers from Kepware
and MatrikonOPC support the Modbus RTU protocol and can be used to connect
with other software programs.
|
LabVIEW Block Diagram using Modbus Serial Driver
|
| |
|
